Shop Categories
More Information Buy Now Listen Now
 
  • TCC

    TCC TC-760 Switchable Moving Magnet/Coil Phono Preamp, Pre-amp (Preamplifier)
    The TC-760's similar MM specs and sound quality rival those of our TC-750, but this model adds the ability to connect moving coil cartridges. Whether you own an MC cartridge now or envision upgrading to one in the future, this preamp gives you the flexiblity to connect both MM and MC cartridge-equipped turntables at the same time, selecting between them with the flick of a switch.
    More Information Buy Now Listen Now
     
  • JBL

    JBL AV1 7.1 Channel Surround Processor
    First MSRP $5,000.00 Analog Audio Inputs Eight stereo (RCA) or five stereo and one 5.1-channel or two stereo and two 5.1-channel connectors Digital Audio Inputs Four S/P-DIF coaxial (RCA) and four S/P-DIF optical (TosLink) connectors; coaxial and optical input connectors conform to IEC-958, S/P-DIF standards; accepts 44.1kHz, 48kHz, 88.2kHz and 96kHz sample rates; accepts 1624 bits PCM audio, Dolby Digital, DTS and DTS-ES discrete data formats Audio Output(s) Eight unbalanced (RCA) connectors for front L/R, center, subwoofer, side L/R and rear L/R Audio Processing Section A/D Conversion 24-Bit, 96kHz, dual-bit architecture D/A Conversion 24-Bit, 44.1kHz to 192kHz, multi-bit architecture Frequency Response 10Hz to 20kHz, +0.05dB/0.1dB, 0.5dB at 40kHz, reference 1kHz THD + Noise Below 0.008% at 1kHz, maximum output level Dynamic Range 108dB minimum, 22kHz bandwidth S/N Ratio 108dB minimum, 22kHz bandwidth Input Sensitivity 200mV RMS (2V RMS for maximum output level) at 0dB input gain Output Level 150mV RMS typical, 6Vrms maximum; maximum value with full-scale input signal and volume at +12dB Video Input & Output Connectors Video Inputs Five composite (RCA), five S-video and three component video (RCA) Video Outputs One composite (RCA), one S-video and one component (RCA) Composite & S-video Performance Compatibility NTSC, PAL and SECAM Impedance 75 Ohms Bandwidth >25MHz Component Video Performance Compatibility 3-Channel (Y/Pr/Pb), format-independent Impedance 75 Ohms Insertion Loss <3dB Bandwidth >150MHz General Trigger Outputs One power on/off and one programmable connector on 5-pin DIN RS-232 Serial Input/Output Two 9-pin D-sub connectors Power Requirements 90 250 VAC, 50Hz 60Hz, 60W (universal line input), detachable power cord Rack Mounting Optional brackets are available for installation in a standard 19" equipment rack (two rack units required for AV1). Dimensions (H x W x D) 3-13/16" x 17-5/16" x 14-7/8" Weight 17 lb/7.7kg
    More Information Buy Now Listen Now
     
  • Marsh Sound Designs

    Marsh P2000b Balanced Stereo Pre-Amplifier
    The P2000b with balanced connections pure class A circuitry is built from advanced bi-polar and field effect transistors (FETs) in a folded cascade configuration that helps to create the MSD hallmarks - clean sound and effortless performance. Simplified controls on the front panel belie the elegant, complex electronics inside. Remote-controls from ALP are known for high quality and compatibility with most fine audio components. The signal path is "direct-coupled" from input to output for musical signal purity, employing Richard Marsh's popularized concept of Servo-Control. The circuits are stabilized for optimum music detail resolution, using special balanced "tracking" regulated power supplies. The P2000b provides maximum gain 20 dB.
    More Information Buy Now Listen Now
     
  • NAD

    NAD PP 3 Digital Phono/USB Preamp
    LP to HD NADs PP-3 combines the award winning PP-2 MM/MC Phono Preamp with a high quality Analog-to-Digital converter with USB interface. Utilizing VinylStudioTM Lite PC Software (CD included) copy your LPs directly to a PC as either .wav or .mp3 files. Once your analog LPs are digitized, the music can be burned onto CD-Rs or transferred to portable music players. The PP-3 also includes the same analog outputs as the PP-2 for connection to an analog stereo system. TECHNICALLY SPEAKING The PP-3 phono preamp consists of a low noise discrete MC preamp followed by a low noise opamp-based RIAA MM stage incorporating a 12 dB /octave infrasonic filter to attenuate turntable rumble noise. The output feeds the Line Output as well as the soft clipped input of an A/D converter with USB Output. This can be connected to any PC for recording from vinyl disc to PC hard drive.
    More Information Buy Now Listen Now